*CHAT* Nice weather, Club RSX bans, K-Swapped GTR, a Unicorn and will Rob's car ever be done chat

[ryaano18]

I have to use a press to take mine off and assemble

That's awesome! I'm needing that in my life, but cannot afford :sadbanana:

I've always used my press for both, the only thing I recall being able to remove without the press is the bearing on top of the main shaft.

really? well shit... all the mainshaft stuff came off with some wiggling. like it was a 45 sec process for me to take it all apart and another 2 min to put it back on.... could that be an issue? Cant find anything specific about it online

[aLmk]

really? well shit... all the mainshaft stuff came off with some wiggling. like it was a 45 sec process for me to take it all apart and another 2 min to put it back on.... could that be an issue? Cant find anything specific about it online

I'm honestly not 100% sure. I'm pretty positive the service manual says to use a press on the main shaft as well. I can say it is significantly harder to press off the gears from the counter shaft than the main shaft.

[ryaano18]

I'm honestly not 100% sure. I'm pretty positive the service manual says to use a press on the main shaft as well. I can say it is significantly harder to press off the gears from the counter shaft than the main shaft.

I went through it as well, and i saw it said to use a press for the gears but I didn't find anything about if the gears just came off lol i was excited at first but then started getting concerned about tolerances of the mainshaft

[PetefromtheStreets]

really? well shit... all the mainshaft stuff came off with some wiggling. like it was a 45 sec process for me to take it all apart and another 2 min to put it back on.... could that be an issue? Cant find anything specific about it online

Hmm. [MENTION=83]vdubkilla[/MENTION] you have this happen to you at all? I've always needed a press