Sounds like great info and timing for a 'bearing info' type thread! (@spaz [MENTION=40]monjarassi[/MENTION] [MENTION=56]PetefromtheStreets[/MENTION] [MENTION=867]ryaano18[/MENTION])
Sounds like great info and timing for a 'bearing info' type thread! (@spaz [MENTION=40]monjarassi[/MENTION] [MENTION=56]PetefromtheStreets[/MENTION] [MENTION=867]ryaano18[/MENTION])
I'll let someone else start the thread n chime in as we go.
Ok so the acl bearings for the a2, will work in my z3 block with my z3 crank just fine? I ask because the tech at acl told my shop differently when he was trying to order bearings.Quote:
Originally Posted by monjarassi
:coffee2: Morning everyone
Quote:
Originally Posted by aLmk
No i refer as to OEM, acl is acl.
So you're not sure if the acl bearings will work? What bearings are you using?Quote:
Originally Posted by monjarassi
Don't know if this helps but I used a2 acl bearings on my z1 crank I'm a a2 block. I know it's not what you are asking but I figured I would post it anyways just incaseQuote:
Originally Posted by aLmk
I'm using the a2 OEM bearings with a type s crank on my z3 crankQuote:
Originally Posted by aLmk
Yea thanks, I'm going with the acl bearings. From what I've read, the crank and rod part numbers are the same for the z3 and a2 so how could the bearings be different? The part numbers for the bearings are different, but that is probably because of the coating monjarassi was talking about.Quote:
Originally Posted by Frostydc5
You mean z3 block? And what made you go OEM rather than ACL?Quote:
Originally Posted by monjarassi