Can anyone give me any pointer for outing my block into an engine stand? And also once the trans is off, where can I attach the hoist to on that side?
So i found out yesterday that you cant mix match interior wire harnesses in the RSX
My base fuel pump clip is only a 2-pin clip, but the type-s is like a 16-pin. So i had to order a new floor harness (40 bucks). ill probably make a wire sleeving basics DIY if anyone is interested in joining the wiring crew
Can anyone give me any pointer for outing my block into an engine stand? And also once the trans is off, where can I attach the hoist to on that side?
If i was home i would take a pic to show you. Pretty much you take the bar out of hoist and using the bolts from the transmission to mount it to the engine where the transmission mounts, you just have to align the mounts to the nearest holes. then pick up the motor and put the bar into the stand. if you're motor still has the crank and pistons in it you might need a friend to help you pick up the motor and put it on the stand
"As I lay rubber down to street, I pray for traction I can keep. But if I spin and begin to slide, please oh please protect my ride."
One-off SRT Top Mount Manifold - GT3076R
My Ruckus Build
I know I'm a day late, but have fun at WCF, and be safe! Good luck guys, and girls!
Who is racing that day from here? [MENTION=878]civicgrl89[/MENTION] and [MENTION=56]Adm_rsx[/MENTION] are, and [MENTION=49]boosted_teg[/MENTION], [MENTION=83]vdubkilla[/MENTION], and [MENTION=921]Frostydc5[/MENTION] will be there to spectate, and I will be there on Sunday as well. Might not bring my Si though
Last edited by Si Speed 317; 11-02-2013 at 01:54 AM.
"As I lay rubber down to street, I pray for traction I can keep. But if I spin and begin to slide, please oh please protect my ride."
One-off SRT Top Mount Manifold - GT3076R
My Ruckus Build
Bookmarks