very nice! I actually looked into making one for real myself. Love the creativity
So guys, a couple days ago I was going through my tool box and happened to find a bracket that I took off my transmission a while back.
And thought to myself this Would work great vs paying 25 bucks from crsx.
So I took and cut out the material between the two existing holes. ImageUploadedByTapatalk1348119321.599983.jpg
ImageUploadedByTapatalk1348119380.618261.jpg
Then ground the tab into a shape of a tooth like on the flywheel.
ImageUploadedByTapatalk1348119458.810499.jpg
Found some washers and a bolt and nut and you slide it through the rear lower hole for a trans bolt to go.
ImageUploadedByTapatalk1348119592.481979.jpg
And your washers are meant to space the tool away from the engine block to line up and mesh with the flywheel teeth.
ImageUploadedByTapatalk1348119811.151732.jpg
I had to place a little angle on the holder for it to work properly but that was no issue. It worked like a champ.
Hope you guys enjoy.
Tire slayer
Breaking everything since 2011
very nice! I actually looked into making one for real myself. Love the creativity
Good job man.
That's awesome! Reminds me of the Ruckus forums, there are so many DIYs for free stuff like this. Gotta love it. Repped for ingenuity
"As I lay rubber down to street, I pray for traction I can keep. But if I spin and begin to slide, please oh please protect my ride."
One-off SRT Top Mount Manifold - GT3076R
My Ruckus Build
Bookmarks