Gonna go to Homedpot/Lows this week and see if i cant piece this all together cause the ones i have on now are pretty much factory and are crap and pain in the ass to get off!!!!!!
I posted in the Suspension section but was suggested to post here too..
One of my Progress rear endlinks was loose and as I tried to tighten it back up I ended stripping the nut. Long story short I dremeled the hell out of it.
But I'm here to shed some light of a cheap alternative way to make your endlink thats cheaper then even the engalls
3/8 Male Heim Link
http://www.jegs.com/i/JEGS+Performan...64103/10002/-1
3/8 Female Heim Link
http://www.jegs.com/i/QA1/122/CFR6/10002/-1
Grade 8 - 3/8 Hex Bolt
http://www.homedepot.com/h_d1/N-5yc1...&storeId=10051
Grade 8 - 3/8 Flat Washer
http://www.homedepot.com/h_d1/N-5yc1...&storeId=10051
Grade 8 - 3/8 Nut
http://www.homedepot.com/h_d1/N-5yc1...&storeId=10051
I couldn't source the small spacers but I managed to reused my old ones off the old endlink (I'm working on sourcing them)
Pictures!
New vs. Old ( I killed it!)
Installed -
Thats pretty much it. Will update if I can source the spacers!
Let me know if you have any questionsNot really boost related but I put this on Clubrsx and fb said post anything
Gonna go to Homedpot/Lows this week and see if i cant piece this all together cause the ones i have on now are pretty much factory and are crap and pain in the ass to get off!!!!!!
So how much did this cost verse a new one
Available now are SPAZ APPROVED decals!!! Available in multiple colors!
Need parts?! Check out our eShop and let me know! We can help you out!
http://boostedk20.com/eshop/
New one lile oem go for about $70 if im not mistaken
Bookmarks