very good post.
repd
Some of you may not know what the inside of a K series engine looks like here are a few pics with some brief comments of a bone stock k 20Z1 short block tear down
Removing the rod bolts to pull pistons and rods
Pistons and rods on the table
pulling the center main bolts
a view from the bottom of the block where the oil pan normally covers
After removing the lower girdle and lifting the crank and bearings out
Lower Girdle
Lower Girdle and Crankshaft
Bare Block you can see where the oil squirters are normally located they are removed in this pic
Pistons , Rods , Girdle , Crank ,and Block
View from the top of the Bore where the Cylinder head bolts to
very good post.
repd
Nice! I'll be tearing mine down eventually.
Clean block [MENTION=185]aLmk[/MENTION]
Great post, thank you for sharing! +Repped
Need parts for your k-series setup? Check out our eShop! Click Here
For all your eShop support needs:BoostedK20.com eShop Support Forum
Subbed to this one too cuz Mark made it...
Bookmarks