I thought it would be good if everyone shared their dyno sheets so we can all see the results please include if it's turbo or supercharged and some minor details about it .
I'll start us off with Three different plots from the past few years from beginning to most recently .
1st dyno is from May 2011 it is an unopened k20z1 with ARP head studs , kelford 179-b cams , supertech springs ret and seats and a full race t4 ts manifold and a Garrett gt35r with twim mvr wg its a crappy pic but put down 585/414 on c16 on 26 lbs this graph was a before and after cams comparison
Next is a pretty recent graph (March 2013) on 93 oct pump gas on 18 lbs now with the addition of sleeving the block ,87mm 10:1 compression ratio cp pistons , manley tt rods ,acl bearings still running the 35r dotted line is pump gas made 556/ 382 on 18 lbs solid is c 16 made 650/440 24 lbs of boost
Since then I had an over rev and have had to rebuild this time 87.5 mm went back with the same set up and same 10:1 comp but pulled the Kelfords after some thought and installed the z1 cams and here is a dyno just on the Wastgates / 8lbs I'll post the latest graph once the tune is complete which should be soon
E dyno 8 lbs
We are now on 20 lbs of boost on pump gas and finishing the tune via data log I will be posting the most recent graph in the near future as the car is a beast on the street
Reply With Quote
Bookmarks