How To Setup Your Catch Can Correctly

[boosted_teg]

could you just put a small filter on the valve cover and a filter on the check valve (when drilled out)?


If you place two 10an bungs on the back of the valve cover, cap the check valve and run the lines to a catchcan, that would essentially work.

we placed a catchcan where the battery use to be, two lines to the valve cover, and two lnes to the oil pan (releave pressure there also)



The bottom two lines were capped for the photos, we didnt have enough time to createthe lines for the car show

[Si Speed 317]

could you just put a small filter on the valve cover and a filter on the check valve (when drilled out)?

You could, but this is about being environmentally safe and doing things properly. Many people have done it, but you have to constantly keep cleaning the air filter, and whatever the excess drips on. Much better off just running a catch can, plus you can see everything that comes out