Spaz is Back and BOOSTED

[PetefromtheStreets]

How did you tell they were fake? I have a feeling mine are.

[aLmk]

The ID injectors I bought used have an extra SN hand engraved into the injectors and when I had them cleaned and flow tested by ID they didn't tell me they were fake. Do yours have the extra SN?

[PetefromtheStreets]

The ID injectors I bought used have an extra SN hand engraved into the injectors and when I had them cleaned and flow tested by ID they didn't tell me they were fake. Do yours have the extra SN?

I'll have to look. I bought mine used as well off crsx.

[Spaz]

haven't even had a chance to look at the photos I took from IA but man I've found some awesome ones online. These I just found from InitialDougie so I thought I would post them on my show-off. Thanks man!

[aLmk]

So here is my newest update. I teamed up with Josh at Annoited Aero and got my hands on the new Mugen 330mm risers.



I took some comparison photos






The bitch of this process was getting my old stands off... Because it's an authentic Mugen wing I used the double sided gasket that came with it so with fishing line, googone and a putty knife I spent a good 2 hours trying to get the stands off...



But then I put the ball and chain to work to clean off all the left over adhesives


Then I used some rubber gasket roll I had and created two new gaskets. They won't be sticky but they will work just fine





And now install and enjoy!

Is the gasket just to prevent scratching the brackets?

haven't even had a chance to look at the photos I took from IA but man I've found some awesome ones online. These I just found from InitialDougie so I thought I would post them on my show-off. Thanks man!

Looking good! How'd the AC unit work out?

[02civic629]

Looking good! How'd the AC unit work out?

This ^^^^ lol

[Spaz]

So here is my newest update. I teamed up with Josh at Annoited Aero and got my hands on the new Mugen 330mm risers.



I took some comparison photos






The bitch of this process was getting my old stands off... Because it's an authentic Mugen wing I used the double sided gasket that came with it so with fishing line, googone and a putty knife I spent a good 2 hours trying to get the stands off...



But then I put the ball and chain to work to clean off all the left over adhesives


Then I used some rubber gasket roll I had and created two new gaskets. They won't be sticky but they will work just fine





And now install and enjoy!

[Spaz]

yeah... so in the garage testing it worked fine... in the real world the fan was just not powerful enough and it didn't do shit... I need a much much more powerful fan.

And yes the gasket is just to help cushion/protect and keep water out of the screw holes going into the side pieces I assume.

[Spaz]

Well... she's back in pieces... blew up another transmission.. and while I'm at it I'll see if I can find this oil leak.. but I'm pretty sure it's a valve guide :emo:



Had to pull this god damn piece of shit out yet again


To start dropped the subframe of course


pulled the turbo kit


here's my mess


how my engine bay sits



Found oil around the manifold


but also oil around the turbo





Took transmission to my buddy Calvin and we opened it up


found some teeth lol


found where they were from


Now to wait for new parts to arrive

[monjarassi]

make sure u drain the gas if the cars gonna be sitting and the inj.