I got the ring gear off the LSD. Those bolts did not want to budge even with the impact, but they finally came off! I took some close up pictures of the slight damage that was done to my FD. I do intend to use the 4.7 fd, so I would like to reuse it, the damage is very minimal. LMK what you all think about reusing it.
(There are 3 damaged spots, I just took pictures from 2 different angles)





Now can anyone tell me how to properly remove the bearings on the LSD it self, and how they are supposed to be installed? I assume you use the press to install, but I have no idea how to remove the bearings (not that I really need to since my LSD is junk, but I'd like to know how). I will be buying an MFactory LSD and will need to install bearings on that.


Also I think Ryan told me in a text to use a socket and hammer to get the bearing off the main shaft, is this how I should do this?

It's pretty awkward to hold and hit at the same time. Suggestions are very welcomed!