05 RSX Type S Rotrex Project

[SAX JONZ]

Thanks for the heads up. No burnouts then.:-D
These tires grip really pretty well, so we will see. Once again, not looking to destroy the trans on it's first trip to the zoo. Gonna go domesticated then the animal will come out.

[SAX JONZ]

Wasn't able to run. They spied my broken stud bolt. I'm going to have to fix that asap.

[aLmk]

Yea when you get to the track and get to the burnout box don't do a burn out. I through the water past it and spin the tires a little just enough to get the water off. Burnout on street toes don't really do much for you. Best of luck and can't wait to hear what you run

s4 IG-petefromthestreets

I drive around the water box But not next time, since I got some slicks

[SAX JONZ]

I saw some pretty sick speed. 7 second quarters that just blew me away and a viper that did a 15 second quarter that just made me LMAO.

[Si Speed 317]

Wasn't able to run. They spied my broken stud bolt. I'm going to have to fix that asap.

Damn. Which stud? I didnt see u were going to the track. My best advice on a stock tranny and axles is to not preload your tranny before you launch. You can do a small burnout, just enough to clean the tires and warm em up a bit (more or less, depending on your compound). I have a set of, uhhh, i forget. But anyways, the set of tires on my stockies (winter wheels) actually grip very well with a nice street burnout. Typically though, street tires don't like much burnout.

When are you going back?

[SAX JONZ]

Its front left. I had gotten a set of mugen seven sided ones. They looked anemic so I bought a set of rays. I guess I put them on too tight. They didn't want to come off so I twisted it off when I should have gotten an impact. I was traumatized when the one side came loose the very first day so I wanted to make sure they wouldn't come loose again.
I went to Route 66. Going back in two weeks. I need to take off the hub to do it properly, correct?

[PetefromtheStreets]

Its front left. I had gotten a set of mugen seven sided ones. They looked anemic so I bought a set of rays. I guess I put them on too tight. They didn't want to come off so I twisted it off when I should have gotten an impact. I was traumatized when the one side came loose the very first day so I wanted to make sure they wouldn't come loose again.
I went to Route 66. Going back in two weeks. I need to take off the hub to do it properly, correct?

I haven't replaced my studs yet but I know im my other cars you could grind a bit off the flat end and it could fit in while the hub is still in place. If you pull the hub off I'd replace the wheel bearings since they are off anyways

s4 IG-petefromthestreets

[SAX JONZ]

Good idea. They have 125k. Couldn't hurt. I want to redo entire suspension

[SAX JONZ]

Well, just got a slap on wrist today. 90 days supervision, then ticket dropped from record. Whewww. Got off LIGHT.
Going back to track on the 27th. I'm bringing cam and hopedully breaking the 13 second mark.

[PetefromtheStreets]

Well, just got a slap on wrist today. 90 days supervision, then ticket dropped from record. Whewww. Got off LIGHT.
Going back to track on the 27th. I'm bringing cam and hopedully breaking the 13 second mark.

Congrats on the win in court. Lol. And cam2 for the track? Mix some c16 in your fuel. Up the ignition timing and go run some mid 12's

s4 IG-petefromthestreets