Well I got the intercooler mocked up, it fit basically as i imagined, but was always wondering how it would end up. It fit like a glove, I ordered the wrong coupler for the tb side and had to cut it up, but ill grab another reducer. I have a lot more mork to do but Im getting closer. The upper water neck needs done still, and ill have to make a new throttle bracket. Ill also be rerouting the fuel line and make some brackets. Getting the bov flanged welded on tomorrow on the endtank. Anyways....










New Tial Q bov came in. I needed some welding done so I dropped some stuff off at Kinetic Motorworks here in NH. Getting 2 -10 an bungs welded to the vc, spare water neck chopped and redone at an angle and the two iacv water ports taken out and welded shut, and bov flange welded on the ic.




Im not sure where to put the breather box/oil catch can, any ideas?