Quote Originally Posted by beppe View Post
the eaton m62 is the same as the jackson same as the one used in the mercedes engine. they port the bottom side blower found this:



is this what is needed to do too ours?

im just seeing if i can get it ported locally from UK than send to USA

also can you guys tell me where i can get some ceramic snout bearings from loads of ebay of the standard bearings kit and seal..
Look up rolling performance for ceramic bearings for the m62.

I dont think they port the bottom of the blower casing- they actually pull the rotor pack out and port the inside of the blower housing for more CFM and more clearance for the rotors as they heat up from higher blower rpm.