So guys, a couple days ago I was going through my tool box and happened to find a bracket that I took off my transmission a while back.



And thought to myself this Would work great vs paying 25 bucks from crsx.

So I took and cut out the material between the two existing holes. ImageUploadedByTapatalk1348119321.599983.jpg



ImageUploadedByTapatalk1348119380.618261.jpg

Then ground the tab into a shape of a tooth like on the flywheel.


ImageUploadedByTapatalk1348119458.810499.jpg

Found some washers and a bolt and nut and you slide it through the rear lower hole for a trans bolt to go.

ImageUploadedByTapatalk1348119592.481979.jpg

And your washers are meant to space the tool away from the engine block to line up and mesh with the flywheel teeth.
ImageUploadedByTapatalk1348119811.151732.jpg


I had to place a little angle on the holder for it to work properly but that was no issue. It worked like a champ.

Hope you guys enjoy.