I just picked up a k&n intake. It's pretty much just a filter with a very small adapter on it. Should be getting it onthe mail this week hopefully.
Joe
1991 Acura NSX
"As I lay rubber down to street, I pray for traction I can keep. But if I spin and begin to slide, please oh please protect my ride."
One-off SRT Top Mount Manifold - GT3076R
My Ruckus Build
Im pretty sure its a MAF sensor. Why is the oil filter not any good?
Joe
1991 Acura NSX
Here's the intake here.
http://www.nsxprime.com/forum/attach...8&d=1339886751
Joe
1991 Acura NSX
Bit of an update. Since getting the maintanence done the car has been running really good. The speedometer was going wonky so I replace the sensor which took care of the problem.
I also replaced the monstrosity of an antenna that came on the car. When the radio was on it must have reached upwards to 6 feet. I replaced it with a stubby.
Then I was preparing her for her first long distance trek to Boston. She ran pretty good other then swaying all over the road. Every rut in the road the car wanted to follow. So we jacked her up and figured out the problem was a bad front left side outter tie rod end and left rear outter ball joint.
And after 1500+kms this is how she looked once she got to sleep for the night.
So the car once again sits up on jack stands and awaits removal and the send off of the knuckle to get a new ball joint installed. Acura doesnt just sell a ball joint, you have to replace the whole knucle/ball joint assembly.
So since the car is up on jack stands
I decided to change up the wheels a bit. About 10 coats of plastidip later and this is the result.
And here was one taken from DT Fredericton. One of my favorites so far for sure.
Joe
1991 Acura NSX
Looks awesome! How much is this going to set you back price wise?
"As I lay rubber down to street, I pray for traction I can keep. But if I spin and begin to slide, please oh please protect my ride."
One-off SRT Top Mount Manifold - GT3076R
My Ruckus Build
For the ball joint? About $250.
Joe
1991 Acura NSX
Damn, you gotta pay to play in exotics territory. Well worth it though, from what I can see. Any new shots with the plasti-dipped wheels?
"As I lay rubber down to street, I pray for traction I can keep. But if I spin and begin to slide, please oh please protect my ride."
One-off SRT Top Mount Manifold - GT3076R
My Ruckus Build
The car is still on jack stands so I havent put the wheels back on. Plus I only had one can of plastidip so I only got 2 wheels done. That shit is crazy expensive here. $20.99 a can here vs. $5.98 a can at Lowes. My inlaws were in Maine for the day so I got them to pick me up 8 cans lol.
Joe
1991 Acura NSX
Bookmarks