Cleaned up my hubs with a wire brush then painted them black to clean them up


then slapped my suspension on



Went ahead and clamped down my Fuel lines, and installed the return line



Also pulled out the studs and bolted down the HR water port for good



Then grabbed my Harness and installed that




My own clutch line I sell



And then had to make a new Map Sensor bracket. So I grabbed out some sheet metal. Traced my map sensor


then did a rough cut out



Now to find hole position I used red marker and a pick to scratch a center


tough to see.. but here is where to drill



Now drilled my holes


drilled the top hole and cleaned it up



Now to install and tuck away