Builds lookin like its gonna be sick Adam and dam I hope I don't see any connecting rods like that .Season is pretty well over with and btw shim the pivot ball with one washer and tack weld an 8 mm nut unto the cmc
Builds lookin like its gonna be sick Adam and dam I hope I don't see any connecting rods like that .Season is pretty well over with and btw shim the pivot ball with one washer and tack weld an 8 mm nut unto the cmc
Post some pics of it on here so I can see. And yea I hope you don't see any like that either. Lol. Your building your motor this winter right?
Tire slayer
Breaking everything since 2011
dam sexy build... we made same power b4 blow up!!!
Yeah Adam I am gonna do pistons , rods , and brngs. this winter not sure when probably jan / feb .I also gotta sump the fuel tank , get another bosch 044 fuel pump to run a twin set up with a -10an feed and have the roll bar made 10 point and of course re tune it lookin for 700-800 on q16 and I wanna stay around 525-550 on pump .That should pretty well complete the car next it'll be the transmission then maybe paint in another year .
Tire slayer
Breaking everything since 2011
Well the 35r should put me over 700 anyway maybe /hopefully better with bigger fuel system and bigger injectors .We are gonna take stock sleeves to about 36- 38 lbs of boost . I launched 20+ times this year well actually 40+ times if you count the burnout box . I am running dss 2.9 axles they are 450-500 hp rated and so far so good I launch at 6500 rpm in third gear at approxx 6-8 lbs of boost
Last edited by vdubkilla; 11-15-2011 at 11:10 PM.
Damn. I didn't think the 35r would pump that much air. Sounds like it gonna be nasty. Can't wait to see it done. I'm gonna get the 5.9's from DSS. They come with hubs too so that will keep my axles good. If I break the trans...oh well. Lol I'll build that too. Lol
Tire slayer
Breaking everything since 2011
Bookmarks