UPDATE: Interior pics on page 2 & few build pics on page 4...
Whats up guys. My name is Luis and Im from NJ. Heres a quick run down of my pride and joy. The car was built by myself from the ground up. Motor was built by Larry at Pro-Motion Race Engines and tuned by the man Yosolo. Car made 431whp @15psi 93 pump gas on the dyno but boost creeps to 19psi on the road. Heres the spec list and just a few pics I have. I plan to do a build thread soon so stay tuned. Hope you enjoy.
Motor:
ITR K20a Type R
Type R Cams
Supertech Titanium dished Valves
Supertech Titanium valve seats
Supertech dual valve springs
CP Pistons 86.5mm 9.0 cr
Manley Turbo Tuff rods
Mahle Clevite race bearings
OEM chains
OEM guides
OEM tensioner
Precision 5831 Turbo
BWR T3 sidewinder manifold
Tial MVS 38mm wastegate
Tial 60mm BOV
ID1000 injectors
Ktuned fuel rail
Ktuned fuel pressure gauge
Aeromotive A1000 fpr
Eagle oil feed plate
Ktuned gaskets
DW65c fuel pump
Earls 10 micron fuel filter
Russell 6an fuel lines (feed & return)
Ktuned an fittings
Vibrant 2.5" piping
Vibrant couplers
Type R 6 speed trans
Type R oem LSD
Clutchmasters stage 4 clutch
Hybrid racing shifter cable bushings
Innovative 75a motor mounts
CXRacing Intercooler
MTEC Trans shifter race springs
SSR Engine torque damper
Samco Sport Radiator hoses
Ktuned AC/PS delete
Custom 3" downpipe (open)
open dump tube
Hondata Kpro
Exterior:
Type R headlights
6000k HID's
LED parking lights
Custom Cupra R Lip
OEM 04-05 sideskirts
Mugen Seibon carbon fiber wing
Custom DIY rear wiper delete
35% tints
Tinted taillights
LED plate lights
Interior:
Corbeou Forza seats
Corbeou 3inch 4 point harness
NRG steering wheel
NRG slim hub
NRG quick release
Buddy club short shifter
Corsport shifter base bushings
Custom radio delete
Broadway mirror
NRG harness bar
Custom X-brace designed by myself
Rear of the car is completely stripped and wire tucked. Painted and clear coated to match exterior paint.
Suspension:
Skunk2 Pro S coilovers
Custom spring lengths and spring rates
10kg front/ 8kg rears
Skunk2 rear camber kit
Spc front camber bolts
Beaks tie bar
Progress tie bar and sway bar
Wheels:
Old setup:
XXR 527 wheels
17x8.25 f/ 205_40 Falken 912's et20
17x9.75 r/ 215_40 Falken 912's et10
New setup:
ESM 007 Platinum edition wheels w/gold rivets
17×9 all around
215_40 Nankang Noble sport NS20
Front et 20
Rear et 5 (using 15mm H&R spacer)
H&R extended studs all around
Here are a few pics. Ill post more as go along
A pic someone took down at H2oi in Maryland
And heres quick pic I snapped after fitting the new wheels and test drive
Dyno vid: https://www.youtube.com/watch?v=UHFo32VPXyo
Reply With Quote
Bookmarks