hi/low boost switch?

[ryaano18]

From what I've gathered so far that's the only wire

Ahhhhh thanks for clarifying that. Well [MENTION=1040]Jonezy[/MENTION] you could still cut it and extend to a switch, or you can depin the brake wire, and repin a flying lead to a switch and just tuck away the oem wire with tape.

[Jonezy]

also, the switches you use. do they need to be the 2 connector or the 3 connector type?

[ryaano18]

also, the switches you use. do they need to be the 2 connector or the 3 connector type?

either will work. 2 pin are regular switches, power to one and signal to other.

3 pin is same except one pin is ground (these are usually for switches with LEDs)

and your diagram is correct

[Jonezy]

Sorry about the relentless questions but this is what I've understood,

This correct?