Hi everyone I am new to this group but I have been an active member on CRSX and K20a (Turbinator's VBP Base Model Accession Show-off Thread - Club RSX Message Board)

FOLLOW ME ON INSTAGRAM: Turbinator1990

I have been planning out this turbo build since I got my 2010 FA5 back in January, 2014 and here are the details to my build:

TURBO PRL BUILD

Engine:
  • Stock k20Z3
  • TSX Throttle Body
  • ARP Head Studs


Fuel:
  • BDL Fuel Rail
  • Injector Dynamics 1000cc Injectors
  • Walbro 255 Fuel Pump


Transmission:
  • Stock k20z3 6-speed
  • Mfactory LSD
  • Stock Clutch (I will see how long it lasts)


Turbo Components:
  • Garrett GTX 3582R (35R) 0.82 A/R
  • PRL Intercooler, Manifold, Downpipe, and Charge Piping
  • Tial MVR 44mm Waste Gate
  • Synapse Radial BOV
  • Full-Race 3" Exhaust


Electronics:
  • FlashPro (I love the new Bluetooth Feature)
  • Omni-Power 4 Bar Map Sensor
  • 4 Port Boost Control Solenoid (VitTuned)


Suspension & Wheels:
  • H&R Lowering Springs (plans to go with Koni Yellow & Swift Springs)
  • Stock Si wheels (Planned to go with RPF1)


September 2014 Engine Build:
  • Wiseco 9.8:1 Pistons
  • Eagle H-Beam Rods
  • Hasport Motor Mounts
  • Supertech ValveTrain (100 psi)
  • Relocation of Intercooler Piping


Update:





Walbaro 255 & Omni 4-Bar Map Sensor


4-Bar Boost Control Solenoid -VitTuning


The PRL Kit has Arrived!:wheee:


Mocking Everything Together










TSX Throttle Body + Custom Charge Piping (Due to the fact PRL forogt to add a mounting plate for the IAT)


Downpipe is installed! It was a challenge to due to the large turbo


Everything is together! I will stick to the stock location of the charge piping till next time. I will be routing underneath the car


Front Bumper is back on, It sucks Fogs do not fit anymore :thumbsdown:









Synpase Blow Off Valve is finally welded on!


3rd Gear Pull Video
https://www.youtube.com/watch?v=VFzgpNOUbdI

Full-Race Exhaust




Open DownPipe Video
https://www.youtube.com/watch?v=i8dV1v9m048

https://www.youtube.com/watch?v=Fa7U2PFXBFY

With New Exhaust
https://www.youtube.com/watch?v=Fa7U2PFXBFY

Ahhh The backfire!
https://www.youtube.com/watch?v=lGMdTv0jNUs

Volk SE37K in Polished Finish (17x8.5+30)...Debating if I should keep these and powdercoat.



TIME TO BUILD THE BLOCK AND HEAD