ive read that you can use a pipe and hammer to tap it in. Plus i gotta replace the bearings in the case and honda recommends the pipe thingy bobber, so ill use that with the mainshaft as well
Ya I bought that tool! Was very helpful for doing everything, good for use with the press as well.
Either the nt03's I originally wanted. I found someone with the concave version, which is the only ones I like. Works CR Kai's or just be a boss and ride around on belaks or welds wheels daily. Just got my first check...and this new job is...substantial
Either the nt03's I originally wanted. I found someone with the concave version, which is the only ones I like. Works CR Kai's or just be a boss and ride around on belaks or welds wheels daily. Just got my first check...and this new job is...substantial
Bookmarks