My06_types build thread...Finally getting somewhere....

[My06_types]

Here is my new build for this past winter/spring. Everything done on this build was done by me and done in the confines of my 2 car garage.

Wish I had more friends and people around to help with the build or answer questions but I don't... which I why I join these pages to ask any questions I can't find.

Anywho... on with the pictures. Let me know what you guys think.. not quite finished yet..

Block
K20z1 Block
JE Pistons 86mm 10:1
Manley Turbo Tuff Rods
ARP Headstuds
OEM 86mm Headgasket
ACL Race rod bearings
Oem main and thrust bearings
Hybrid Racing Timing Chain tensioner
New oem timing chain

Head
K20z1 Head
Supertech std Valves
Supertech Dual Valve Springs
Supertech Valve Seats
Supertech Ti Retainers
Supertech bronze valve guides
Multiangle Valve Job


Transmission...
Not much as of now.
Stage4 CC clutch
K-tuned race shifter
K-tuned race shifter cables

Turbo Setup
Full race twin scroll efr kit
Borg Warner EFR 8374 dbb Turbo
Tial 60mm Wastegates
Tial Blow Off Valve if I use it...

Fuel System
Hybrid racing Fuel Rail
Walbro 255 Intank Pump
Integrated engineering 2.3L dual pump sump
Dual bosch 044 fuel pumps
8AN Feed
6AN Return
Deutsch works1000cc Injectors
HR Fuel Pressure Regulator
HR Fuel Pressure Gauge
Aeromotive inline fuel filter

Other
wireworx stage 3 Engine Harness
Shaved RBC Intake Manifold
Hybrid racing 70mm Throttle Body
Innovative 75A Motor Mounts
Hondata 4-Bar MAP Sensor
Hondata Boost Control Solenoid
K-Tuned Billet TPS
BWR oil sandwich Adapter
Electronic Power Steering
Relocated Fuse Box to pass air bag
Relocated Battery to hatch
Engine bay shaved and tucked by me
K-Tuned Pulley Kit


Interior
AEM Wideband UEGO Gauge
AEM Digital Oil Pressure Gauge
AEM Digital Boost Gauge
Steering Wheel
Steering Hub
Record seats


Suspension/Wheels & Tires
Buddy Club N+ Coilovers
new oem front control arm buahinga
17 x 9+30 rota torques
245/50/17

Exterior
ASPEC Front Lip
ASPEC Rear Lip
ASPEC Sideskirts
ASPEC Wing
Engine Bay welded, shaved, and tucked...All by me!













Hand formed all the sheet metal and welded her up!!