Quote Originally Posted by K24_Acura_EL View Post
The latest new on my build is that i spun a rod bearing last month . So before i put the car away for storage for this winter , i am taking the motor out and going to rebuild it and rebuild it to run the JRSC in mind. I am looking at a putting in better rods and pistons in the new block to make some more power and change my TSX exhaust cam to the Si exhaust cams.

Any other suggestion ?? i would like to make 350 hp with my setup if i can and i am looking for the support bracket that bolts under the manifold of the M62 to the block of the motor.
Sorry to hear that. 350 is definitely a doable goal, are you running an aftercooler for starters? That, along with a smaller blower pulley (assuming all stock other pulleys) would be a great start (with the appropriate sized injectors)
Quote Originally Posted by Spaz View Post
that sucks... damn spun bearing


I ended up making my own support bracket. Wasn't tough.

As far as 350 it's not a hard goal. K24 CP, 3.0 BP, Aftercooler, MercRacing Inlet, good tune. Maybe even look into E85 that'll put you over for sure.
you can even run the 2.9 or 2.8" MercRacing pulley! He'd love to help you out with your goals [MENTION=974]MercRacing[/MENTION]