-
Ep3 fuel quick fitting
Hi guys.
I need an adaptor for connecting my oem fuel fitting to an AN6 teflon fuel hose,
I have all the fittings aside from the quick connect to an6 to the hardline on the bulkhead, it seems to be smaller than the 5/16" used on the fuel rail connectors
A good guess would be that it's 6mm/ 1/4". Yet I'm really struggle to find one. Anybody else done this
-
[MENTION=1040]Jonezy[/MENTION] let's get these guys to chime in
[MENTION=28]Spaz[/MENTION] [MENTION=56]PetefromtheStreets[/MENTION] [MENTION=185]aLmk[/MENTION] [MENTION=40]monjarassi[/MENTION] [MENTION=2]Si Speed 317[/MENTION] [MENTION=193]Xander[/MENTION] [MENTION=775]Poita[/MENTION] [MENTION=1029]Shanket[/MENTION]
-
That's a tough one I been looking
-
Actually, our BoostedK20 Si used the stock fuel fitting with the -6 K-Tuned rail. We used a Hybrid Racing adapter piece. Check that out, let me know if that's what you're looking for. http://www.hybrid-racing.com/store/engine/fuel-fittings [MENTION=1040]Jonezy[/MENTION]
-
Have you tried that ?
http://www.summitracing.com/parts/RUS-641303
Fits perfectly on the FA5! Not sure about the EP3 though...
-
i just did a -6an or -8an from firewall to fuel rail
-
I just used a bunch of clamps cause back when I changed rails no one knew of a quick release fitting. But now you can buy them
-
Where exactly do you need this fitting to go? To connect the oem hardline to the bulkhead fitting at the cage?
-
Amlk - yes pal. I'm trying to run an an hose from the bulkhead hardline. As I'm using teflon line it doesn't clamp down as well as rubber stuff,
-
[MENTION=28]Spaz[/MENTION] - that looks the size pal. I measured it with caliper as 6.1mm I think, which is near as dammit 1/4".
Thanks for the input. Just got to find one this side of the pond!