Printable View
Ya but after riding in your car last weekend, our 6th on the 4.3 is kinda too low for me. I rarely cruise for long periods at 80+ because I don't make many long trips. And if you look at the gear ratios, the 02-04 type-s has the same ratio 6th as the 5 speed's 5th, and it uses a 4.3 FD, so to me that means it was more designed for it. But depending on how much it would all cost to get that 6th gear, I would just use my 6th gear with the 4.3Quote:
Originally Posted by snizzletoff
I decided to adjust my rear suspension because I realized I had too much preload on the rear springs, and apparantly, according to Buddy Club, I followed incorrect instructions when installing these because the measurements changed after 06 and the instructions I was following was for 06 Sis. So change the spring perch to what the guy suggested for approximately a 1.5'' drop and I lengthened the strut as much as I could, but still had to preload the spring at least an inch (this was a big improvement over the previous preload which was closer to 3 or 4'') but still isn't in the desireable range of 0-10mm of preload. So I'm not sure why my strut just doesn't seem to be long enough... Anyway here are some pictures of what I'm talking about.
http://i1134.photobucket.com/albums/...pscc39833e.jpg
http://i1134.photobucket.com/albums/...psa5ac23ff.jpg
So I jacked the hub up to preload the spring, put the car on ground, drove around my street to get things to settle in... Then I went to the trunk to torque down the lock nuts on top of the strut, the torque rating is 22 ft/lbs. I was unable to get to 22 ft/lbs before tightening the nut started to twist the rod on the strut which I am assuming is bad, so I stopped there. This is what it looks like after tightening:
http://i1134.photobucket.com/albums/...ps75b5b193.jpg
http://i1134.photobucket.com/albums/...psd7a292aa.jpg
Does this look/sound right to those with experience with coilovers? Note these coilovers have been on the car for over a year, so the spring should already be 'settled'.
Received this pic earlier today:
http://i1134.photobucket.com/albums/...g?t=1377010505
:waiting:
HOLY FUCK OF A W.G!!
s4 IG-petefromthestreets
Interesting........
Ya it's a 2'' wastegate neck, I will be using a 45mm turbosmart gate.Quote:
Originally Posted by Adm_rsx
Did you express to him how much you didn't want to boost creep? Lol looks like you ought to have no issue now. :thumb:Quote:
Originally Posted by aLmk
s4 IG-petefromthestreets
Yes over and over LOLQuote:
Originally Posted by Adm_rsx
LOL thought that Convo may have happened once, twice or thrice times lolQuote:
Originally Posted by aLmk
s4 IG-petefromthestreets
Made some progress today:
http://i1134.photobucket.com/albums/...ps8b26b6c1.jpg
God damn is this a tight as spot to be working in... I did this and injected my front mount today, now I gotta eat lunch and get ready for work :sadbanana: Gonna try to finish the timing chain job Saturday after work.
In other news, the manifold is supposed to be back to Sheepey today from the ceramic coater so hopefully he can ship it today or tomorrow :waiting: Also if I can't source a second gear within the next couple days, I will be taking this transmission out, breaking it down, and sending these gears along with my 4.3 FD off to get treated by racer steve.
:beer: