Printable View
i also use pushlock lines and fittings. All the fittings are drilled/tapped on the bottom side of my rbc. However, i think id be careful with which line you use with the pushlocks. I had some cheap black line, and when i stored the car i noticed it became very flimsy (maybe the heat?). I could literally pinch the line with 2 fingers completly closed. Maybe this is part of my creep issue.
Mmmm Thunder mug from Boston Pizza
http://sphotos-b.ak.fbcdn.net/hphoto...21303055_n.jpg
What kind of beer? A local car restaurant has a 43 ounce mug I love it!
sent via spazatalk
Quote:
Originally Posted by boosted_teg
I bought my line from jegs. It's black also but It's very sturdy. I can't close my line at all with my fingers.
:thumb:Quote:
Originally Posted by Si Speed 317
Hard to say. I'd check over all my connections and hoses that run off my IM. Make sure you don't have any cracks or loose clamps. I believe I found out what my idle issue was and it was loose IM bolts and a loose connection to my vacuum block.Quote:
Originally Posted by Si Speed 317
I am going to use the same line I have on my WG to vacuum block. On the one with AN fitting did you teflon tape them?
You only Teflon npt threads. AN fittings are designed to need no sealant.Quote:
Originally Posted by ksboi
43oz mug? Niiice! this is the biggest mug we could get here, and its coors light draft, nothing special haha
as for the line, you got good line. The new line i bought is nice and sturdy also
Ya I think the largest in DE I've heard of is 25oz
i believe that mug i had is a 32oz