Hmm i see
anyways
A couple goodies to get the intercooler installed
http://i39.photobucket.com/albums/e1...m/IMAG2166.jpg
Hmm i see
anyways
A couple goodies to get the intercooler installed
http://i39.photobucket.com/albums/e1...m/IMAG2166.jpg
I LOVE frozen boost!
Whats frozen boost? I assume a dope spot for intercooler ish?
they sell water to air intercoolers, ice boxes, water lines, piping, etc... plus other common turbo goodies, couplers, clamps etc... oil and water coolers. all kinds of stuff, and the pricing is good too!
I'm gonna go check oil coolers tomorrow from there now that you mention it. :thumb:Quote:
Originally Posted by bodyman
Well I got the intercooler mocked up, it fit basically as i imagined, but was always wondering how it would end up. It fit like a glove, I ordered the wrong coupler for the tb side and had to cut it up, but ill grab another reducer. I have a lot more mork to do but Im getting closer. The upper water neck needs done still, and ill have to make a new throttle bracket. Ill also be rerouting the fuel line and make some brackets. Getting the bov flanged welded on tomorrow on the endtank. Anyways....
http://i39.photobucket.com/albums/e1...m/IMAG2173.jpg
http://i39.photobucket.com/albums/e1...m/IMAG2177.jpghttp://i39.photobucket.com/albums/e1...m/IMAG2180.jpg
http://i39.photobucket.com/albums/e1...m/IMAG2174.jpg
http://i39.photobucket.com/albums/e1...m/IMAG2170.jpg
http://i39.photobucket.com/albums/e1...m/IMAG2183.jpg
http://i39.photobucket.com/albums/e1...m/IMAG1969.jpg
New Tial Q bov came in. I needed some welding done so I dropped some stuff off at Kinetic Motorworks here in NH. Getting 2 -10 an bungs welded to the vc, spare water neck chopped and redone at an angle and the two iacv water ports taken out and welded shut, and bov flange welded on the ic.
http://i39.photobucket.com/albums/e1...m/IMAG2186.jpg
http://i39.photobucket.com/albums/e1...m/IMAG2187.jpg
Im not sure where to put the breather box/oil catch can, any ideas?
Looks gorgeous, I love how the turbo and intercooler and throttle body are also close to each other. Makes me want to do a w2a intercooler! As for the catch can, it depends on where you plan on putting the new bungs on the valve cover. Are you going to have the two bungs in front like most, plug the intake manifold, and the punch out the PCV port so you can attach to the catch can as well? Answer these and we"ll figure out a nice spot. Which catch can do you have? Breather I hopeQuote:
Originally Posted by bodyman
Sorry forgot to post that, I am picking up my valve cover tomorrow, 2 -10 bungs welded to the front of it
What about the IM/pcv part of my post? LolQuote:
Originally Posted by bodyman
the pass side port on the IM I have my booster vaccum hose going to it. and the top blocked off, the PCV valve is still sitting the way it is, its open atm, should I block it off?? This is my first turbo car so I need some advice on this oneQuote:
Originally Posted by Si Speed 317