Best intake Manifold and Throttle Body

You can make 700-800 on stock tb and manifold

But i did find out that they do make an adaptor plate like a spacer for the 72mm dbw throttle body

Quote:

---

Originally Posted by echo3gulf

But i did find out that they do make an adaptor plate like a spacer for the 72mm dbw throttle body

---

thatll work too

Quote:

---

Originally Posted by jendry20

You can make 700-800 on stock tb and manifold

---

I still run a stock rbc and type s tb on my set up .I have thought of upgrading but havent felt the need as of yet

i was going to stick to my OEM tb aswell but the new IM wont allow me to do so

IMO is waste of money unless you planning making the most power you can like 1000-1300... People make 800-900 on stock rbc and tb

Quote:

---

Originally Posted by jendry20

IMO is waste of money unless you planning making the most power you can like 1000-1300... People make 800-900 on stock rbc and tb

---

thats very true

not true they make three models

Quote:

---

Originally Posted by jendry20

IMO is waste of money unless you planning making the most power you can like 1000-1300... People make 800-900 on stock rbc and tb

---

I agree. IMO if you charge piping is still 2.5'' then that will just become the restriction. And with turbo setups we are blowing through the throttle body so it needing to be really big is less of a concern than for someone that is NA or has a roots blower that is after the throttle body.

i just went from RBC and 70mm to AFI and 90mm tb. We'll see what kind of improvements it makes on the dyno. Nothing else is changing, so should be good back to back comparison. I got it pretty cheap and it'll clean up the bay quite a bit