Thats what happened with me. I started doing my own and just got overwhelmed and decided it was better to order one than stress about making my own.Quote:
Originally Posted by Rmenjoi33
Printable View
Thats what happened with me. I started doing my own and just got overwhelmed and decided it was better to order one than stress about making my own.Quote:
Originally Posted by Rmenjoi33
How much did you end up spending if you dont mind asking. You can text it to me if you want.Quote:
Originally Posted by Turpid Porpoise
lol honestly, I would usually suggest people to buy a harness from ry-wire or wireworx because building one yourself is very time consuming and still pretty pricey. You do get the added benefit of knowing that you did that yourself and a little of how the wiring worksQuote:
Originally Posted by Rmenjoi33
However, when i get to the engine harness part of the build i will post a DIY on sleeving/labeling it to help out anyone who wants to experiment on theirs
When you make my floor/dash harness you can make a DIY on that too :giggle:Quote:
Originally Posted by ryaano18
Yea, the engine harness has a lot of loops and junctions and logic grounds, this wire splits off to 7 other wires kinda shit lolQuote:
Originally Posted by Turpid Porpoise
I just want to wrap mine lol. I want to make the wires that need heat proofing to look good. Can I just wrap them in heat tape and then cover with loom lol.Quote:
Originally Posted by ryaano18
in for a beast to be finished
You can wrap them in christmas wrapping paper if you want.Quote:
Originally Posted by Rmenjoi33
die.Quote:
Originally Posted by Turpid Porpoise
Yup, thats what ill be doing to the ect, tdc, and cps sensors. Just tightly wrap the bare wires with the heat foil pad thingy, and then take the 1000 degree loom and slide it over and finish with a heat shrinkQuote:
Originally Posted by Rmenjoi33