PDA

View Full Version : FREE Flywheel holder tool



PetefromtheStreets
09-20-2012, 01:44 AM
So guys, a couple days ago I was going through my tool box and happened to find a bracket that I took off my transmission a while back.

http://img.tapatalk.com/d/12/09/20/u3ehapu5.jpg

And thought to myself this Would work great vs paying 25 bucks from crsx.

So I took and cut out the material between the two existing holes. 72
http://img.tapatalk.com/d/12/09/20/yjebumy8.jpg

http://img.tapatalk.com/d/12/09/20/badytu7e.jpg
73

Then ground the tab into a shape of a tooth like on the flywheel.

http://img.tapatalk.com/d/12/09/20/jujypeju.jpg
74

Found some washers and a bolt and nut and you slide it through the rear lower hole for a trans bolt to go.
http://img.tapatalk.com/d/12/09/20/9uvy3a2u.jpg
75

And your washers are meant to space the tool away from the engine block to line up and mesh with the flywheel teeth.
76
http://img.tapatalk.com/d/12/09/20/ra3uvy9u.jpg

I had to place a little angle on the holder for it to work properly but that was no issue. It worked like a champ.

Hope you guys enjoy.

Spaz
09-20-2012, 10:18 AM
very nice! I actually looked into making one for real myself. Love the creativity

PetefromtheStreets
09-20-2012, 11:11 AM
very nice! I actually looked into making one for real myself. Love the creativity

Thanks man. Was a simple solution that took 10-15 minuets maybe and didn't cost me a dollar compared to the 25 dollar tool off kseriesparts.com

ksboi
09-21-2012, 03:39 AM
Good job man.

Si Speed 317
09-23-2012, 12:23 PM
That's awesome! Reminds me of the Ruckus forums, there are so many DIYs for free stuff like this. Gotta love it. Repped for ingenuity :thumb:

PetefromtheStreets
09-23-2012, 02:37 PM
That's awesome! Reminds me of the Ruckus forums, there are so many DIYs for free stuff like this. Gotta love it. Repped for ingenuity :thumb:

Thanks man.